Tension shower rod keeps falling!

[Anonymous]

Any advice? can’t drill because tiles are everywhere. Thanks.

[Anonymous]

And you extended them as far as you could to make sure they're really tight against the wall? Also did you clean the tiles before mounting the rod?

[Anonymous]

You can drill into tile! You just need a mason drill bit. Tension rods are terrible.

[Anonymous]

Get small 3m command hooks and put the command pads until the two ends of the rod. The adhesive should be enough to keep the rods from slipping and if/when you decide to change the curtain or rod, then you can remove the adhesive.

[Anonymous]

You can drill into tile.

[Anonymous]

What shower rod are you using? You need one with really grippy ends and with a screw to hold the tension.

[Anonymous]

And yes, agree that you can drill into tile.

[Anonymous]

I wouldn't want to drill into the tile either depending on how old it is or how long I plan to have the tension rod.

I'd use the 3M tape to hold it in place, and stop flinging the shower curtain... just pull it slowly open and closed.

[Anonymous]

small round of double sided tape (for friction) + more tension!